The tent area has been explored in two areas called Dor and Tekken. This area is located in the central part of the geological map of one hundred thousandth of Dehq. In the division of structural zones of Iran, this area is part of the northeastern side of Sanandaj-Sezjan. Lower and upper Cretaceous stratigraphic units as well as Quaternary sediments are the main deposits of 1: 20,000 in and Tekken sheets. Drift faults were active in the north and northeast within K1ml and K1sh.m units. The general trend of thrust faults is northwest and southeast. Normal faults are observed with the general east-west trend. The axis of folds in the region is mostly northwest-southeast. Due to the compressive forces, folds have been created in the region, the most important of which are the anticlines and synchronies north of the sheet. For exploratory geochemical studies, 178 soil samples, 18 samples of stream sediments and 35 samples of heavy minerals were collected and analyzed. The elements lead and zinc indicate the local threshold and can be expected to be enriched. Also, in heavy mineral studies, lead minerals, especially galena, have been significantly identified. In general, hematite, magnetite, galena, serosite, pyrolusite, pyrite, chalcopyrite and iron hydroxide ores are found in hand samples and polished sections. Public exploration data in the tent area provide evidence of possible economic mineralization of lead and zinc in the area. In the detailed exploration stage, 58 powder boreholes up to a depth of 56 meters have been drilled by the drill wagon in the exploration area. The total amount of powder drilling is 2111 meters. A total of 1420 powder samples for lead, zinc and oxide parameters of these metals have been analyzed by atomic absorption (AA) method. However, most samples did not contain measurable amounts of lead zinc. 19 core boreholes have been drilled in the exploration area. The total drilling depth is 2859.5 meters. The minimum drilling depth is 91 meters and the maximum is 273.4 meters. The average drilling depth in this project is 150.5 meters. 869 samples of drilled cores subjected to chemical decomposition of lead and zinc by atomic absorption (AA) method were analyzed. Few drilling rigs are economically viable. . Given that the deposit has been explored using boreholes focused on exploratory profiles, the vertical section method has been used to calculate; Accordingly, 15,738 tons of minerals with a grade of 2.46% lead and 1.69% zinc are estimated in this range. This amount of reserves is not economical to build a lead and zinc mine, and thus the exploration operations carried out did not lead to the discovery of acceptable reserves for the construction of the mine.